126
Installing & Setup the Driver
7.
Use the USB cable to connect the XV-5050 and your computer.
fig.USB-01
8.
In some cases, the
“Insert Disk” dialog
box may appear.
Click “OK.”
9.
The “New Hardware Found” dialog
box will appear.
In the
“Copy files from”
area, input
“D:\Win98”
and click the
“OK”
button.
Installation will be completed.
* Change the drive name D: to match the drive
name of your CD-ROM drive. For example if
your CD-ROM drive is named Q:, you would
input “Q:\Win98”.
10.
Click “OK” button in the “SETUPINF” dialog box.
Then refer to
Specifying the Output Destination for MIDI Data
(the section that
follows), and make settings for the XV-5050 to be used from your computer. The XV-
5050 cannot be used unless you make these settings.
To prevent malfunction
and/or damage to speakers
or other devices, always
turn down the volume, and
turn off the power on all
devices before making any
connections.
USB cable
XV-5050
USB connector
of your computer
Computer
XV-5050_e.book 126 ページ ２００３年６月２７日 金曜日 午後３時１４分
To Next Page
Loading...
Need help?
General