134
Installing & Setup the Driver
Using FreeMIDI on the Macintosh
Installing the XV-5050 Driver
Use the following procedure to install the XV-5050 driver.
* Disconnect the XV-5050 from your Macintosh before installing the driver.
* Exit all applications before you begin installing the driver.
* The
XV-5050 FreeMIDI Driver
included on the disc is provided as an additional module
that allows the XV-5050 to be used with FreeMIDI. In order to use it, FreeMIDI must
already be installed on the start-up hard disk.
1.
In the “XV-5050 Driver E” folder of the CD-ROM, double-
click the “FM-E” icon.
2.
Make sure that FreeMIDI is already installed
in the location where the driver will be
installed, and click [Install].
3.
When installation is completed, click
[Restart] to restart your Macintosh.
This completes installation of the XV-5050 Driver.
Next you will make FreeMIDI settings.
You can download
FreeMIDI from the Web
site of Mark of the Unicorn,
Inc.
About detailed information
for FreeMIDI, refer to the
owner’s manual of
FreeMIDI.
XV-5050_e.book 134 ページ ２００３年６月２７日 金曜日 午後３時１４分
To Next Page
Loading...
Need help?
General