70
Chapter 4 Using the XV-5050 Effects
Patch/Rhythm Set Mode
Settings
Only one Multi-effect, Chorus, or Reverb effect can be set for each
Patch or Rhythm Set. You cannot apply differing types of Multi-
effects, Chorus, or Reverb to each of the Tones or Rhythm Tones
comprising the Patch or Rhythm Set.
Basic Process of Making Effects
Settings
When applying effects in Patch/Rhythm Set mode, the following
procedure is used to make the settings.
1.
Setting the Output Method of the Direct Sound (Output
Assign)
Settings determining whether or not the signal passes through
the Multi-effects, the jack used to output the sound, and the type
of output (stereo or mono) are made for each individual Patch or
Rhythm Set, or each Tone or Rhythm Tone. -> (p. 71)
2.
Setting the Amount of Each Effect Applied (Send Level)
Set the level (volume) of each effect signal to be sent for each
Tone or Rhythm Tone. -> (p. 71)
3.
Making Multi-Effects Settings
Select the type of Multi-effects to be used, and set the parameters
for the selected Multi-effect. -> (pp. 74–101)
4.
Setting the Multi-Effects Controller
When using MIDI messages to change the Multi-effects
parameters in realtime, select the Multi-effects controller. -> (p.
74)
5.
Setting the Output Destination and Volume for the Sounds
Passing Through the Multi-Effects
Select the output jack and set the output level (volume) of the
sounds passing through the Multi-effects. You can also apply
Chorus or Reverb to the sound that passes through Multi-effects.
-> (p. 74)
6.
Making Chorus Settings
Select the Chorus type to be used, and set each of the parameters
for the selected Chorus. -> (p. 74, p. 102)
7.
Setting the Output Destination and Volume for the Sounds
Passing Through the Chorus
Select the output jack and set the output level (volume) of the
sounds passing through the Chorus. You can also apply Reverb
to the sound that passes through Chorus. -> (p. 74)
8.
Making Reverb Settings
Select the Reverb type to be used, and set each of the parameters
for the selected Reverb. -> (p. 74, p. 103)
9.
Setting the Output Destination and Volume for the Sounds
Passing Through the Reverb
Select the output jack and set the output level (volume) of the
sounds passing through the Reverb. -> (p. 74)
Audio Signal Flow
The audio path of direct sounds or sounds that have been passed through the effects in Patch/Rhythm Set mode is shown in the figure below.
fig.3-01
A
B
CHO
TONE/
RHYTHM
TONE
OUTPUT A
OUTPUT B
REV
M-FX
Output Assign
M-FX
Output Assign
Chorus
Output Assign
Reverb
Output Assign
XV-5050_e.book 70 ページ ２００３年６月２７日 金曜日 午後３時１４分
To Next Page
Loading...
Need help?
General