Ruijie Reyee RG-NBR-E Series User Manual

Cookbook Overview
5
No.
Indicator/Port
Description
9
GE copper ports
Eight 10/100/1000M self-adaptive fast Ethernet ports (copper ports 0-7) that
support automatic recognition of network cables and crossover cables:
LAN0 (GE 0/0) port is a LAN port and WAN0 (GE 0/7) port is a WAN
port, and they do not support the WAN/LAN switchover.
LAN6/WAN1 (GE 0/6) is WAN port by default and supports the
WAN/LAN switchover.
LAN1/WAN6 (GE 0/1), LAN2/WAN5 (GE 0/2), LAN3/WAN4 (GE 0/3),
LAN4/WAN3 (GE 0/4), LAN5/WAN2 (GE 0/5) are LAN ports by default
and support the WAN/LAN switchover.
In bridge mode, LAN0 (GE 0/0) port is also the MGMT port.
10
Reset
Restarts the router. Press and hold this button for more than 5 s to reset the
router to factory defaults.
11
SYS
System indicator:
If it blinks green, the system is being initialized.
If it is steady green, system initialization is completed.
If it is steady red, the system is in abnormal state.
Figure 1-4 Back Panel of Ruijie RG-NBR6205-E Router
Table 1-5 Description of the Back Panel of Ruijie RG-NBR6205-E Router
No.
Indicator/Port
Description
1
Retainer holder
Holds the power cord retainer to secure the power cord.
2
Power port
Connects to an AC power cord.
3
Power switch
Controls power supply.
4
Grounding screw
Connects to the grounding system of the installation site through the
grounding wire to provide grounding protection.
5
Hard disk expansion
card slot
Fits the hard disk module. The supported hard disk module model is
RG-NBR-HDD-1T.
2 3
5 4
1

Ruijie Reyee RG-NBR-E Series Specifications

General

Brand	Ruijie
Model	Reyee RG-NBR-E Series
Category	Network Router
Language	English