Network setup_ 26
3.network setup
This chapter gives you step-by-step instructions for setting up the network connected machine and software.
This chapter includes:
• Network environment
• Introducing useful network programs
• Using a wired network
• Wireless network setup
• IPv6 configuration
• If you are using wired network environment, see "Using a wired
network" on page 26.
• If you are using wireless network environment, see "Wireless
network setup" on page 32.
Network environment
You need to set up the network protocols on the machine to use it as your
network machine. You can set up the basic network settings through the
machine's control panel.
The following table shows the network environments supported by the
machine:
Introducing useful network programs
There are several programs available to setup the network settings easily in
network environment. For the network administrator especially, managing
several machines on the network is possible.
Before using the programs below, set the IP adress first.
SyncThru™ Web Service
Web server embedded on your network machine, which allows you to:
• Configure the network parameters necessary for the machine to connect
to various network environments.
• Customize machine settings.
(See "Using SyncThru™ Web Service" on page 60.)
SyncThru™ Web Admin Service
Web-based machine management solution for network administrators.
SyncThru™ Web Admin Service provides you with an efficient way of
managing network devices and lets you remotely monitor and troubleshoot
network machines from any site with corporate internet access. Download
this program from http://solution.samsungprinter.com.
SetIP
This utility program allows you to select a network interface and manually
configure the IP addresses for use with the TCP/IP protocol. (See
"Setting
IP address" on page 27)
TCP/IPv6 is not supported by this program.
Using a wired network
You must set up the network protocols on your machine to use it on your
network. This chapter will show you how this is easily accomplished.
You can use network after connecting network cable to a corresponding
port on your machine.
Printing Network Configuration report
You can print a Network Configuration Report from the machine’s control
panel that will show the current machine’s network settings. This will help
you to set up a network and troubleshooting problems.
Item Requirements
Network interface • Ethernet 10/100/1000 Base-TX
• 802.11 b/g/n Wireless LAN (Optional)
Network operating system • Windows
2000/XP/2003/2008/Vista/7/2008
Server R2
• Various Linux OS
• Mac OS X 10.3 ~ 10.6
• UNIX
Network protocols • TCP/IPv4
• DHCP, BOOTP
• DNS, WINS, Bonjour, SLP, UPnP
• Standard TCP/IP Printing(RAW), LPR,
IPP
• SNMPv 1/2/3, HTTP(S), Telnet, SMTP,
IPSec
• TCP/IPv6 (DHCP, DNS, RAW, LPR,
SNMPv 1/2/3, HTTP(S), IPSec
(See "IPv6 configuration" on page 39.)
Wireless Security • Authentication : Open System, Shared
Key, WPA Personal, WPA2 Personal
(PSK), WPA Enterprise, WPA2
Enterprise
• Encryption : WEP64, WEP128, TKIP,
AES
To Next Page
Loading...
Need help?
General
Weight and Dimensions
