NAS (Network Attached Storage) guide
J
`
When you use the NAS, you might be unable to save data due to temporary network
disconnections.
`
If the setting allows a Micro SD memory card and the NAS to be simultaneously connected for
use, the higher priority for recording goes to the NAS.
`
If you activate Overwrite to the NAS by setting it to <Off> and the available capacity is below 1%,
it will be saved in the Micro SD card.
`
If you are saving data in the NAS, you might be unable to save it when you insert a Micro SD
memory card used by another camera.
`
NAS recommended specs : Refer to “NAS recommended specs”. (Page 11)
`
If you change the NAS saving while saving data in the NAS, it will not be reflected in the system
immediately.
`
If you remove NAS equipment on your own while saving data, or if the network is disconnected,
NAS saving operation will be terminated abnormally.
`
As a rule of thumb, you are recommended to use one NAS sharing directory per camera without
duplicated use.
The following is a description of how to save data using the NAS according to the Synology
NAS method, which is one of the recommended products.
1. Access the Synology NAS as an admin.
In this example, the NAS IP Address is
set to [192.168.20.253].
2. If you access it as an admin, the
following screen will be displayed. Click
the [Control Panel].
setup screen
116_ setup screen
To Next Page
Loading...
Need help?
General
