EasyManuals Logo
Home>Sanyo>Projector>PLC-XU101

Sanyo PLC-XU101 User Manual

Sanyo PLC-XU101
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
38
Move the red frame pointer to a
mode and press the SELECT
button.
The selected image mode is check marked.
Image Select Menu
Image Select
Menu icon
IMAGE button
Dynamic
Cinema
Image 1
Image 2
Image 3
Image 4
Image Mode Selection
Blackboard
(Green)
Standard
Remote Control
IMAGE
button
Video Input
Standard
Cinema
Blackboard(Green)
For viewing with the user preset image mode in the Image
Adjust Menu (see page 39–40).
Image1–4
Select the desired image mode from among Dynamic,
Standard, Cinema, Blackboard (Green), Image 1, Image 2,
Image 3, and Image 4 by pressing the IMAGE button on the
remote control.
Standard
Picture mode adjusted with fine tone.
Cinema
Blackboard (Green)
Image 1–4
For the image projected on a blackboard.
This mode help enhance the image projected on a blackboard.
This is mainly effective on a green colored board, not truly
effective on a black colored board.
For the image projected on a blackboard. See above for
further description.
Dynamic
Dynamic
Direct Operation
For viewing pictures in a bright room.
Normal picture mode preset on the projector.
For viewing with the user preset image mode in the Image
Adjust Menu (see page 39–40). This Image memory is
provided in each computer, component, and video input
source.
Press the MENU button to display the On-Screen
Menu. Use the Point 7 8 buttons to move the red
frame pointer to the Image Select Menu icon.
1
2
Use the Point ed buttons to move the red frame
pointer to the desired image mode and then press the
SELECT button.
Menu Operation
For viewing pictures in a bright room.
Normal picture mode preset on the projector.
Picture mode adjusted with fine tone.

Table of Contents

Other manuals for Sanyo PLC-XU101

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sanyo PLC-XU101 and is the answer not in the manual?

Sanyo PLC-XU101 Specifications

General IconGeneral
Matrix size0.8 \
Vertical scan range50 - 100 Hz
Horizontal scan range15 - 100 kHz
Projection technologyLCD
Contrast ratio (typical)500:1
Screen size compatibility33 - 300 \
Projector native resolutionXGA (1024x768)
Keystone correction, vertical±40 °
OutputD-Sub15 x 1
Video inRCA x 1
Audio inputYes
Aspect ratio4:3
Dimensions (WxDxH)334 x 232 x 78 mm
Connectivity technologyWired
Lamp power275 W
Light source typeLamp
Noise level29 dB
Dot clock scanning frequency140 MHz
Audio (L/R) in2
Headphone outputs1
Display resolution786 x 432 pixels
Power consumption (typical)385 W
Weight and Dimensions IconWeight and Dimensions
Weight3500 g

Related product manuals