43
Operation with a PABX
Gigaset A200 / englisch / A31008-A200-B101-1-7619 / pabx.fm / 16.01.2003
Operation with a PABX
The following settings are only necessary if your PABX requires them, please refer to
the operating instructions for your PABX.
Dialling procedure and flash time
The phone is supplied with DTMF preset (DTMF = Dual Tone Multifrequency Dialling)
and a flash time of 120 ms. The current setting is indicated by a
‰.
Changing the dialling procedure
You have the following options for the dialling procedure:
◆ Tone dialling (DTMF),
◆ Pulse dialling (IWV).
Setting the flash time
[_______________]
MENU
Press display key to open menu.
[__________] [______________________________________________] [__________]
BASE SET OK
Select and confirm.
[__________] [______________________________________________] [__________]
ADD FEATURES OK
Select and confirm.
[______________________________________________] [__________]
DIAL MODE OK
Confirm.
[ _____ _____] [____ __]
OK
Select dialling procedure and confirm.
Long press (return to idle status).
[_______________]
MENU
Press display key to open menu.
[__________] [______________________________________________] [__________]
BASE SET OK
Select and confirm.
[__________] [______________________________________________] [__________]
ADD FEATURES OK
Select and confirm.
[__________] [______________________________________________] [__________]
TBR OK
Select and confirm.
[ _____ _____] [____ __]
OK
Select flash time (80 ms, 100 ms, 120 ms, 180 ms,
250 ms, 300 ms or 600 ms) and confirm.
Long press (return to idle status).
To Next Page
Loading...
Need help?
General