7
Making the phone ready for service
Gigaset A200 / englisch / A31008-A200-B101-1-7619 / starting.fm / 16.01.2003
Step 2: Making the handset ready for service
Remove protective film
Insert batteries
◆ Insert the batteries the right way round – see illustration left.
◆ Place the cover on the battery compartment about 3mm down from the latch and
push it up until it clicks into position.
To open the cover, press on the ridged section and push downwards.
Step 3: Registering the handset with the base station and charging
the batteries
Place your handset in the base station with the display visible at the front – the con-
firmation tone will ring (rising sequence of tones). The handset will then register itself
automatically with the base station (page 33), all symbols flashing in the display. The
process takes about a minute. Once completed, "1" will appear in the top, left-hand cor-
ner of the display. This handset has been allocated the first internal number.
Only for A200 Duo: To register a second handset, proceed as described above. After
successful registration, "2" will then appear in the top, left-hand corner of the display.
The handset display is protected by a film.
Please remove the protective film!
W
◆ Insert only approved, rechargeable batteries of the same type
(page 46)! Never use normal batteries, since these could lead to a
health hazard or cause injury.
◆ Do not use a non-Siemens charging unit as this could damage the
batteries.
i
◆ To register further handsets, see page 33 onwards.
To Next Page
Loading...
Need help?
General