Siemens Gigaset A 200 User Manual

45
Appendix
Gigaset A200 / englisch / A31008-A200-B101-1-7619 / appendix.fm / 16.01.2003
Appendix
Questions and Answers
If you have questions about your phone, look under
www.my-siemens.de/kundenservice
where we can be contacted around the clock. In
addition we have included here the most frequently asked questions and their answers.
What happens if … Possible cause Possible solution
… the display is blank? The handset is not
switched on.
The batteries are empty.
Press the end call key a for
approx. 5 secs.
Charge or replace batteries
(page 7).
… the handset doesn't react to
a key being pressed?
The keypad protection is acti-
vated.
Press the hash key
R for
approx. 2 secs (page 8).
… all the icons are flashing in
the display and there is no con-
nection with the base station?
The handset is outside the
range of the base station.
The handset has not been reg-
istered.
The base station is not
switched on.
The cable has not been cor-
rectly placed in the bottom of
the base station.
Reduce distance between
handset and base station.
Register handset (page 33).
Check power cable plug on
base station (page 6).
Check cable placement
(page 6)
… (where multiple handsets
are in use) the handset in the
base station is not charging?
Charging in the base station
only takes place when a phone
call is not being made at the
same time.
Use additional charger unit.
… the handset does not ring? The ringer is switched off.
The ringer volume has been
set to "0".
Call divert has been set on
AUTOMATIC.
Switch on (page 40) ringer.
Increase ringer volume
(page 39).
Deactivate call divert
(page 20).
… the caller can't hear me? You've pressed the
INT key. As
a result the handset has been
"muted".
Activate the microphone again
with MENU, BACK, OK
(page 16).
… despite CLIP, the caller's
number is not displayed?
Sending the phone number
(CLI) has not been enabled.
The caller should request the
network operator to enable the
transfer of his or her phone
number.
… entries in the caller list don't
show time or date?
Date and time have not been
set.
Set date and time (page 13)
… I can't hear the ringer or dial-
ling tone?
You have changed the phone
cable on your Gigaset.
When buying a cable at a spe-
cialist shop make sure it has the
correct plugs (page 47).
… I can hear an error tone
(descending tone sequence)
when keying in?
The task has been unsuccessful
or the entry is faulty.
Repeat the process; watch the
display when doing so and if
necessary check with the oper-
ating manual.

Siemens Gigaset A 200 Specifications

General

Brand	Siemens
Model	Gigaset A 200
Category	Telephone
Language	English