Siemens SICAM TM User Manual

Assembly
36 SICAM TM, Installation
Edition 10.2014, DC6-015-2.04
3.6.1.1. Removing/Shifting the Optical Bus Interface Module
To remove the optical bus interface module again, or to change its position on the TS35 rail,
the carrier rail retainer on the back panel of the housing must be opened.
One achieves this by pushing with one finger from above on the moving part of the carrier rail
retainer , or from below with one finger hooked into this movable part and pulling downward
. In both cases the carrier rail retainer opens and the module can be removed  or shifted.
3.6.2. Electrical Ax Bus
Designation Item Number/ MLFB
Ax 1703 bus interface electrical GA0-843
6MF11110AJ430AA0
The electrical Ax Bus Module can be installed on the TS35 rail and removed again by hand,
without any tools.
For details concerning the handling of a TM module refer to section 3.7
, Installing TM
Modules.
2
1
3

Siemens SICAM TM Specifications

General

Brand	Siemens
Model	SICAM TM
Category	Controller
Language	English