To Next Page

To Previous Page

Tables

Multifunctional Danger Control and Indicating Panels SIGMASYS C and M (M-Modules) 125 / 128

Best.Nr. A24205-A337-B970 – Edition 12 (03/07)

Tables

Sorted in order of appearence

Table 1: Guidelines for failure of the display unit and signal processor................................... 8

Table 2: Overview of control and indicating panel selection.................................................. 10

Table 3: Control and indicating panel limitations ................................................................... 11

Table 4: Allocation of event location numbers ....................................................................... 12

Table 5: Allocation of event locations in the peripheral elements in FDnet ........................... 12

Table 6: Dimensions for SIGMASYS control and indicating panels....................................... 14

Table 7: Layout of the SIGMASYS M .................................................................................... 19

Table 8: Determining maximum current................................................................................. 20

Table 9: Overview of interfaces ............................................................................................. 24

Table 10: Summary of SIGMASYS M interface with SOC P, SIGMANET P ......................... 25

Table 11: Protocol printer DL3750+....................................................................................... 25

Table 12: Protocol printer T2240/9 ........................................................................................ 26

Table 13: Thermal printer FD60............................................................................................. 26

Table 14: Printer protocol converter....................................................................................... 27

Table 15: Programming in SIGMAPLAN................................................................................ 29

Table 16: Operating panel display ......................................................................................... 29

Table 17: BMT/IMT mixed mode............................................................................................ 35

Table 18: Alarm counters....................................................................................................... 35

Table 19: Relay module - technical data................................................................................ 42

Table 20: Technical data, voltage, current dimensions.......................................................... 52

Table 21: Cycle time for signals from transponders and contact couplers ............................ 53

Table 22: SIGMALOOP extinguishing interface-overview of the features ............................. 58

Table 23: List of approved power supply units....................................................................... 60

Table 24: Monitored control lines........................................................................................... 64

Table 25: Mains supply..........................................................................................................70

Table 26: Bridging time.......................................................................................................... 71

Table 27: Pulse-polling detector elements and evaluation procedures ................................. 81

Table 28: Operating conditions and sample applications ...................................................... 82

Table 29: Line parameter....................................................................................................... 83

Table 30: Example of how to calculate the load factor .......................................................... 85

Table 31: Supported Sinteso

™

elements ............................................................................... 87

Table32: Parameter sets for FDOOT, FDO and FDT detectors ............................................ 88

Table33: Parameter sets for flame detectors FDF221 and FDF241...................................... 88

Table34: Parameter sets for linear smoke detector FDL241-9.............................................. 88

Table35: Parameter sets for alarm devices ........................................................................... 89

Table36: List of load factors for elements.............................................................................. 90

Table 37: Using a modem...................................................................................................... 96

Table 38: Operating panels.................................................................................................... 97

Brand	Siemens
Model	SIGMASYS C
Category	Control Panel
Language	English

Siemens SIGMASYS C User Manual

Table of Contents

Questions and Answers:

Siemens SIGMASYS C Specifications

Related product manuals