Siemens SIGMASYS C User Manual

Inhalt
Inhalt
1 Introduction ......................................................................................................... 1
1.1 About the manual .................................................................................................. 2
1.2 Further information................................................................................................ 3
1.2.1 Documentation ...................................................................................................... 3
1.2.2 Information on the Internet .................................................................................... 3
1.2.3 Training courses.................................................................................................... 4
1.3 Notational conventions.......................................................................................... 4
2 Important notes ................................................................................................... 5
2.1 Notes on application of these project planning instructions. ................................. 6
2.2 Tools required ....................................................................................................... 6
3 Guidelines for project planning ......................................................................... 7
3.1 Limitations ............................................................................................................. 8
3.2 Guidelines for failure of the display unit and signal processor .............................. 8
3.3 Overvoltage protection measures ......................................................................... 8
4 Project planning for control and indicating panels ......................................... 9
4.1 Control and indicating panel selection................................................................. 10
4.1.1 Alarm numbers .................................................................................................... 10
4.1.2 Programming limitations at control and indicating panels ................................... 11
4.2 Selecting the installation location ........................................................................ 12
4.2.1 Fire protection system requirements ................................................................... 12
4.2.2 Control room requirements.................................................................................. 13
4.2.3 SIGMASYS control and indicating panel: installation dimensions....................... 13
4.3 SIGMASYS C control and indicating panel assignment...................................... 16
4.4 SIGMASYS M control and indicating panel assignment ..................................... 18
4.4.1 Assigning option slots in the SIGMASYS M ........................................................ 19
4.4.2 Layout of the SIGMASYS M................................................................................ 19
4.4.3 Dual SOC ............................................................................................................ 20
4.4.4 SOC P module (since end 2006)......................................................................... 20
4.4.5 SIGMANET P coupler (from mid-2006)............................................................... 21
5 Interfaces ........................................................................................................... 23
5.1 Overview of interfaces......................................................................................... 24
5.2 Printers................................................................................................................ 25
5.2.1 Protocol printer DL3750+ .................................................................................... 25
5.2.2 Protocol printer T2240/9 (DR 2030) .................................................................... 26
5.2.3 Thermal printer FD60 .......................................................................................... 26
5.2.4 Printer protocol converter.................................................................................... 27
5.3 GMA Manager (TOPSIS) .................................................................................... 27
5.3.1 Spur operating panels (Version 3.0 and later)..................................................... 27
5.3.2 D100 Interfaces (Version 3.0 and later) .............................................................. 28
6 Functions ........................................................................................................... 31
6.1 Event implementation.......................................................................................... 32
6.2 Daytime/Nighttime ............................................................................................... 32
6.3 Alarm organization .............................................................................................. 32
6.4 Two-detector-zone dependency.......................................................................... 33
6.5 Two-detector dependency................................................................................... 33
Multifunctional Danger Control and Indicating Panels SIGMASYS C and M (M-Modules)
Best.Nr. A24205-A337-B970 – Edition 12 (03/07)

Siemens SIGMASYS C Specifications

General

Brand	Siemens
Model	SIGMASYS C
Category	Control Panel
Language	English