12-1
TP27, TP37 Equipment Manual
Release 01/00
Installation
The Touch Panels TP27 and TP37 are designed for vertical installation in the
front panels of switching cabinets. Cut a mounting slot in the front panel in
preparation for installation of the Touch Panel. The thickness of the front panel
must not exceed 6 mm. No other holes need to be drilled for mounting.
Details regarding the mounting depth and mounting slot are provided in chap-
ter 14.
The IP65 degree of protection for the front panel can only be ensured when the
seal on the front plate of the Touch Panel is fitted correctly.
!
Caution
S The TP must be brought to room temperature before it is commissioned. If
condensation forms, do not switch on the TP until it absolutely dry.
S To prevent the Touch Panel from overheating during operation,
– the angle of inclination specified in the technical data must not be
exceeded,
– do not expose the TP to direct sunlight
– ensure that the ventilation slits in the housing remain free after installa-
tion.
S When the cabinet is opened, certain parts of the system that may conduct
hazardous voltage are exposed.
S The TP was function–tested before shipping. If a fault occurs nevertheless,
please enclose a full account of the fault when returning the TP.
Installation
location and
conditions
Degree of
protection
12
To Next Page
Loading...
Need help?
General
