Siemens simatic ipc227e User Manual

Technical specifications
7.7 Functional scope in Windows
SIMATIC IPC227E
Operating Instructions, 11/2016, A5E35782395-AB
129
7.6.7
Alarm, error and system messages
During startup (the boot process), the BIOS first performs a
P
ower
O
n
S
elf
T
est (POST) and
checks whether certain functional units of the PC are operating error-free. The boot
sequence is immediately interrupted if critical errors occur.
BIOS initializes and tests further functional units if the POST does not return any errors. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The error messages output by system BIOS are listed below. For information on error
messages output by the operating system or application programs, refer to the
corresponding manuals.
On-screen error messages
On-screen error message
Meaning / tip
Operating system not found Possible causes:
• No operating system installed
• Incorrect active boot partition
• Wrong boot drive settings in SETUP
Keyboard controller error Controller error.
Contact your technical support team.
SMART failure detected on HDD
Hard disk reports pending failure through S.M.A.R.T.
CMOS battery failed
CMOS battery is not connected.
CMOS battery weak
CMOS battery is weak
Real-time clock has lost power The CMOS clock was operated without battery or with a bat-
tery that was too weak, during battery change, for example.
Check the CMOS clock.
Keyboard error
• Field PG: Internal keyboard defective and no external
keyboard connected
• Other devices: Keyboard defective or not connected
PLD configuration failed
Programming of the PLC on the motherboard has failed.

Siemens simatic ipc227e Specifications

General

Brand	Siemens
Model	simatic ipc227e
Category	Industrial PC
Language	English