Siemens Simatic IPC527G User Manual

Expanding and assigning parameters to the device
5.4 Memory module
SIMATIC IPC527G
Operating Instructions, 03/2019, A5E45491226-AA
41
5.4
Memory module
Dual channel memory
The motherboard provides two DDR4 memory sockets and supports dual channel technology.
The memory capacity of the device can be upgraded to a maximum of 2 × 16 GB. You can use
approximately 3.2 GB of this memory in a 32-bit operating system and much more in a 64-bit
operating system.
The table below shows the supported memory types of motherboard.
Module type
Module Size
Description
DDR4‐SDRAM
16GB
DDR4 2048M × 64 SODIMM 260pin
DDR4‐SDRAM 8GB DDR4 1024M × 64 SODIMM 260pin
DDR4‐SDRAM
4GB
DDR4 512M × 64 SODIMM 260pin
Requirement
● The device is disconnected from the power supply.
● All connecting cables on the device are unplugged.
NOTICE
Electrostatic discharge
The electronic components on the PCBs are highly sensitive to electrostatic discharge.
Always take appropriate precautionary measures when handling these components. Refer
to the ESD directives on handling electrostatic sensitive components.
Note
Siemens strongly recommends that you use only memory modules approved by Siemens.
Siemens disclaims any liability for impairment of functions caused by the use of third
-party
memory modules.

Siemens Simatic IPC527G Specifications

General

Brand	Siemens
Model	Simatic IPC527G
Category	Industrial PC
Language	English