Siemens SIMATIC IPC677D User Manual

Technical support
A.3 Notes on the use of third-party modules
SIMATIC IPC677D
176 Operating Instructions, 09/2014, A5E32995420-AC
A.3
Notes on the use of third-party modules
Problem
Possible cause
To correct or avoid error
The PC crashes
during startup.
• I/O addresses are assigned
twice.
• Hardware interrupts and/or
DMA channels are assigned
twice
• Signal frequencies or signal
levels are not adhered to
• Different connector pin
assignments
Check your computer configuration:
• If the computer configuration corresponds with factory state,
please contact your technical support team.
• If the computer configuration has changed, restore the
original factory settings. Remove all third-party modules,
then restart the PC. If the error no longer occurs, the
third-party module was the cause of the fault. Replace this
module with a Siemens module or contact the module
supplier.
If the PC still crashes, contact your technical support team.

Siemens SIMATIC IPC677D Specifications

General

Brand	Siemens
Model	SIMATIC IPC677D
Category	Industrial PC
Language	English