EasyManuals Logo
Home>Siemens>Engine>SIMOTICS S-1FT7

Siemens SIMOTICS S-1FT7 User Manual

Siemens SIMOTICS S-1FT7
408 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
Configuration
5.2 Procedure when engineering
S-1FT7 synchronous motors
Configuration Manual, 09/2018, A5E45099423B AA
109
5.2.1
1. Clarification of the drive type
Select the motor on the basis of the required torque (load torque), which is defined by the
application, e.g. traveling drives, hoisting drives, test stands, centrifuges, paper and rolling
mill drives, feed drives or main spindle drives.
Gearboxes to convert motion or to adapt the motor speed and motor torque to the load
conditions must also be taken into account when selecting the motor.
You must know the following mechanical data in order to determine the torque to be supplied
by the motor:
The load torque specified by the application
Masses to be moved
Diameter of the drive wheel
Leadscrew pitch, gear ratios
Frictional resistance data
Mechanical efficiency
Traversing distances
Maximum velocity
Maximum acceleration and maximum deceleration
Cycle time
5.2.2
2. Specification of the supplementary conditions and integration into the
automation system
Take the following into account during the confguration:
The line system configuration when using specific motor types and/or line filters
The utilization of the motor rated values for winding overtemperatures of 60 K or 100 K
(for synchronous motors)
The ambient temperatures and the installation altitude of the motors and drive
components
The heat dissipation from the motors through natural ventilation, forced ventilation or
water cooling
Other conditions apply when integrating the drives into an automation environment such as
SINUMERIK or SIMOTION.
For motion control and technology functions (e.g. positioning), as well as for synchronous
operation functions, the corresponding automation system, e.g. SIMATIC S7-1500 or
SIMOTION D is used.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMOTICS S-1FT7 and is the answer not in the manual?

Siemens SIMOTICS S-1FT7 Specifications

General IconGeneral
BrandSiemens
ModelSIMOTICS S-1FT7
CategoryEngine
LanguageEnglish

Related product manuals