Disposal
11
When carrying out any work, carefully observe the information provided in Chapter "Safety
instructions (Page 13)".
11.1 Disposing of packaging material
The packing is designed in such a way as to pose the minimum risk to the environment. Some
of the packaging can be recycled.
The disposal of packaging is controlled by country-specific laws. If in doubt, ask your local
disposal specialists or contact the local authorities.
The packing material consists of the following components:
● Wooden frames
● Wooden pallets
● Polyethylene foil
● Plywood
● Plastic
● Silica gel
11.2 Removing device components and old devices
If you correctly dispose of the materials, none of the materials pollutes the environment. When
disposing or reusing, comply with the local laws and regulations.
WARNING
Improper disassembly
In the event of an improper procedure during disassembly, material can slip, tilt, and fall down.
This can result in death, serious injury or material damage.
● Only specialist personnel may disassemble and dispose of device components and old
devices using appropriate protective clothing.
● Shut down the device before disassembling. Ground the device
● With old devices, also follow the instructions in the section "Transport."
For the following components, pay special attention when disposing or reusing:
● Batteries
● Capacitors
SINAMICS SL150 6SL38600UL432AA0Z
Operating Instructions Rev.201910281433 EXAMPLE 105
To Next Page
Loading...
Need help?
General