1
2
radio waves use the same frequency as radio waves emitted from microwaves and
wireless LANs (IEEE802.11b/g/n).
There are people or obstacles (such as metal objects or walls) between the TV and remote
control.
A microwave is being used nearby
There is a wireless LAN access point nearby
The TV and remote control are unpaired
In these cases, try the following solutions.
Use the remote control closer to the TV
Remove obstacles between the TV and remote control
Use the remote control when a microwave is not in use
Turn off other Bluetooth devices
Check the TV’s Bluetooth setting and turn it on and off
Press the (Quick Settings) button on the remote control and select the following in order.
If [Settings] — [Remotes & Accessories] — [Bluetooth] is disabled, enable it. If it is enabled,
disable and then enable it again.
Set wireless LAN access points and microwaves at least 10 m away from the TV
If the 5 GHz band (IEEE802.11a) is available in the wireless LAN, connect to the 5 GHz band
Pair the remote control again
Press the (Quick Settings) button on the remote control, and select the following in order.
[Settings] — [Remotes & Accessories] — [Remote control] — [Connect via Bluetooth] —
[Connect a new remote] — follow the on-screen instructions to reconnect the remote control.
If you cannot operate the TV with the supplied remote control, select the above in order until
[Connect a new remote] using another Sony TV's remote control, and then try connecting
again with the supplied remote control.
Depending on your model, a Bluetooth remote control is supplied and already paired
with the TV. At the time of shipment, the supplied paired remote control cannot be
used to operate other TVs. When checking remote control operation, use with the TV
with which the remote control was supplied.
Reset the remote control
If the remote control does not operate correctly due to poor battery contact or static
electricity, the problem may be resolved by resetting the remote control.
Remove the batteries from the remote control.
Press the power button on the remote control for three seconds.
To Next Page
Loading...
Need help?
General