100
Audio dubbing
You can record an audio sound to add to the original sound on a tape by connecting
audio equipment or a microphone. If you connect audio equipment, you can add sound
to your recorded tape by specifying the starting and ending points. The original sound
will not be erased. You can also use the Remote Commander for this operation.
The relationship between audio input and channels on which a
dubbed sound will be recorded
The relationship between audio input and channels on which a dubbed sound will be
recorded is as follows:
Audio input
through
AUDIO IN/OUT CH-1/
CH-2
AUDIO IN/OUT CH-1
AUDIO IN/OUT CH-2
AUDIO IN CH1/CH2
AUDIO IN CH1
AUDIO IN CH2
MIC IN +48V
The position of the
AUDIO INPUT
switch (CH-1/CH-2)
–
–
–
FRONT/FRONT
FRONT/REAR
REAR/FRONT
REAR/REAR
FRONT/FRONT
FRONT/REAR
REAR/FRONT
REAR/REAR
FRONT/FRONT
FRONT/REAR
REAR/FRONT
REAR/REAR
FRONT/FRONT
FRONT/REAR
REAR/FRONT
REAR/REAR
Which audio input will be recorded
on
Channel 3 Channel 4
AUDIO IN/OUT AUDIO IN/OUT
CH-1 CH-2
AUDIO IN/OUT –
CH-1
– AUDIO IN/OUT
CH-2
––
– AUDIO IN CH2
AUDIO IN CH1 –
AUDIO IN CH1 AUDIO IN CH2
––
––
AUDIO IN CH1 –
AUDIO IN CH1 –
––
– AUDIO IN CH2
––
– AUDIO IN CH2
MIC IN +48V MIC IN +48V
MIC IN +48V –
– MIC IN +48V
––
To Next Page
Loading...
Need help?
General
