12
Installing the battery pack
Install the battery pack to use your camcorder outdoors.
(1) While sliding BATT RELEASE in the direction of the arrow 1, slide the
battery terminal cover in the direction of the arrow 2.
(2) Insert the battery pack in the direction of the arrow.
To remove the battery pack
The battery pack is removed in the same way as the battery terminal cover.
Note on the remaining battery time indicator
The remaining battery time indicator on the LCD screen or in the viewfinder roughly
indicates the recording time. The indicator may not be correct, depending on the
conditions in which you recording. When you close the LCD panel and open it again, it
takes about 1 minute for the correct remaining battery time to be displayed.
Note on battery terminal cover
To protect the battery terminals, install the battery terminal cover after the battery pack
is removed.
Step 1 Preparing the power supply
1 2
1
2
To Next Page
Loading...
Need help?
General