17
Recording – Basics
5
4
3
2
40min
REC
0:00:01
1
POWER
VTR
MEMORY
CAMERA
OFF
POWER
VTR
MEMORY
CAMERA
OFF
L
O
C
K
L
O
C
K
— Recording – Basics —
Recording a picture
Your camcorder automatically focuses for you.
(1) Remove the lens cap and pull the lens cap string to fix it.
(2) Install the power source and insert a cassette. See “Step 1” and “Step 2” for
more information (p. 9 to p. 14).
(3) Pull out the viewfinder until it clicks.
(4) Set the POWER switch to CAMERA while pressing the small green button. The
power lamp under the POWER switch flashes, and then your camcorder is set
to the standby mode. (It takes about five seconds.)
(5) Press START/STOP. Your camcorder starts recording. The “REC” indicator
appears. The camera recording lamp located on the front of your camcorder
lights up. To stop recording, press START/STOP again.
Microphone
Camera recording
lamp
After recording
(1) Set the POWER switch to OFF.
(2) Set the viewfinder back to the previous position.
(3) Eject the cassette.
(4) Remove the battery pack.
LOCK
To Next Page
Loading...
Need help?
General