26
— Playback – Basics —
Playing back a tape
You can monitor the playback picture on the LCD screen. You can control playback
using the Remote Commander supplied with your camcorder.
(1) Install the power source and insert the recorded tape.
(2) Press OPEN to open the LCD panel.
(3) Set the POWER switch to VTR while pressing the small green button. The
power lamp lights up.
(4) Press
to rewind the tape.
(5) Press
to start playback.
(6) Adjust the volume following the steps below.
1 Press FN to make PAGE1 appear (p. 15).
2 Press VOL. The screen to adjust volume appears.
3 Press –/+ to adjust the volume.
–: to make the volume down
+: to make the volume up
(7) Press OK. to return to PAGE1/PAGE2.
the bar indicator
5
4
3
6
1
2
VOL
–+
OK
FN
POWER
VTR
MEMORY
CAMERA
OFF
L
O
C
K
To return to FN
Press EXIT.
To stop playback
Press x.
To Next Page
Loading...
Need help?
General