54
Searching for a photo without using cassette memory
(1) Set the POWER switch to VTR.
(2) Press FN to display PAGE1 (p. 15).
(3) Press MENU, then set CM SEARCH in
to OFF in the menu settings (p. 76).
(4) Press SEARCH MODE on the Remote Commander repeatedly, until the photo
search indicator appears.
The indicator changes as follows:
TITLE SEARCH t DATE SEARCH t PHOTO SEARCH t PHOTO SCAN
t no indicator
(5) Press . or > on the Remote Commander to select the photo for playback.
Each time you press . or >, your camcorder searches for the previous or
next photo.
Your camcorder automatically starts playback of the photo.
To stop searching
Press x on the Remote Commander or on your camcorder.
Scanning photo
(1) Set the POWER switch to VTR.
(2) Press SEARCH MODE on the Remote Commander repeatedly, until the photo
scan indicator appears.
The indicator changes as follows:
TITLE SEARCH t DATE SEARCH t PHOTO SEARCH t PHOTO SCAN
t no indicator
(3) Press . or > on the Remote Commander.
Each photo is played back for about 5 seconds automatically.
To stop scanning
Press x on the Remote Commander or on your camcorder.
Searching for a photo – Photo search/Photo scan
2 1
FN
POWER
VTR
MEMORY
CAMERA
OFF
L
O
C
K
5
=+
4
SEARCH
MODE
PHOTO 00
SCAN
To Next Page
Loading...
Need help?
General