20
Adjusting the brightness of the LCD screen
(1) In the standby/recording mode, press FN and select PAGE2 (p. 15).
(2) Press LCD BRT. The screen to adjust the brightness of the LCD screen appears.
(3) Adjust the brightness of the LCD screen using –/+.
– : to dim
+: to brighten
(4) Press
OK to return to PAGE1/PAGE2.
To return to FN
Press EXIT.
Note
When using the LCD screen except in the mirror mode, the viewfinder automatically
turns off.
When you use the LCD screen outdoors in direct sunlight
The LCD screen may be difficult to see. If this happens, we recommend that you use the
viewfinder.
When you adjust angles of the LCD panel
Make sure if the LCD panel is opened up to 90 degrees.
Picture in the mirror mode
The picture on the LCD is a mirror-image. However, the picture will be normal when
recorded.
During recording in the mirror mode
ZERO SET MEMORY on the Remote Commander does not work.
Indicators in the mirror mode
The STBY indicator appears as Xz and REC as z. Some of the other indicators appear
mirror-reversed and others are not displayed.
When you press FN
The does not appear on the LCD screen or in the viewfinder.
LCD screen backlight
You can change the brightness of the backlight. Select LCD B.L. in the menu settings
(p. 76).
Even if you adjust the LCD screen backlight or brightness of the LCD screen
The recorded picture will not be affected.
Recording a picture
1
2,3
FN
180°
90°
LCD
BRT
LCD BRT
–+
OK
the bar indicator
OPEN
To Next Page
Loading...
Need help?
General