Playback
Playback
49
When your TV is connected to a VCR
Connect your camcorder to the LINE IN input
on the VCR using the A/V connecting cable. Set
the input selector on the VCR to LINE.
When your TV is monaural (When your
TV has only one audio input jack)
Connect the yellow plug of the A/V connecting
cable to the video input jack and connect the
white or the red plug to the audio input jack of
your TV or VCR.
When you want to play the sound in monaural
mode, use a connecting cable (optional) for that
purpose.
b Note
• Pictures in the DV format are not output from the
COMPONENT OUT jack, if copyright protection
signals are recorded in the pictures.
Locating a scene on a
tape for playback
Searching quickly for a desired
scene – Zero set memory
1 During playback, press ZERO SET
MEMORY on your camcorder or
Remote Commander at the point you
want to locate later on.
The tape counter is reset to “0:00:00” and
appears on the screen.
If the tape counter is not displayed, press
DISPALY/BATT INFO.
2 Press x (stop) when you want to stop
playback.
3 Press m (rewind).
The tape stops automatically when the tape
counter reaches “0:00:00.”
4 Press N (play).
The playback starts from the point
designated “0:00:00” on the tape counter.
,continued
To Next Page
Loading...
Need help?
Imaging
Audio
Power
Weight and Dimensions
