Playback
50
To cancel the operation
Press ZERO SET MEMORY again.
b Note
• There may be a discrepancy of several seconds
between the time code and the tape counter.
• Zero set memory will not function correctly if there
is a blank section between recorded sections on the
tape.
Searching for a scene by date of
recording – Date search
You can locate the point where the recording
date changes.
1 Set the POWER switch to VCR.
2 Press SEARCH MODE on the Remote
Commander repeatedly to select
[DATE SEARCH].
3 Press . (previous)/> (next) on
the Remote Commander to select a
recording date.
You can select the previous or the next date
of the present point on the tape.
Playback starts automatically from the
point where the date changes.
To cancel the operation
Press STOP on the Remote Commander.
b Note
• If 1 day’s recording is less than 2 minutes, your
camcorder may not accurately find the point where
the recording date changes.
• The Date search will not function correctly when
there is a blank section between recorded sections on
the tape.
Searching for a recording start
point – Index search
You can locate the point where an index
signal is recorded (p. 39).
1 Set the POWER switch to VCR.
2 Press SEARCH MODE on the Remote
Commander repeatedly to select
[INDEX SEARCH].
3 Press . (previous)/> (next) on
the Remote Commander to select an
index point.
You can select the previous or the next
index signal of the present point on the tape.
Playback starts automatically from the
point where the index signal is recorded.
To cancel the operation
Press STOP on the Remote Commander.
b Note
• If 1 day’s recording is less than 2 minutes, your
camcorder may not accurately find the index point.
• The Index search will not function correctly when
there is a blank section between recorded sections on
the tape.
. / >
SEARCH MODE
STOP
. / >
SEARCH MODE
STOP
To Next Page
Loading...
Need help?
Imaging
Audio
Power
Weight and Dimensions
