¥
t
to DVI-D
output
CJ
Computer
to
monitort
output
[J
""
§
0000 0000
0000
0000
11-
__
l!
~
..
,
Rear of the projector
•
•
•
•
•
•
•
·•
•
•
""--------_
_----------..,." .
HD
D-sub15-pin cable (not supplied) or HDMI-DVI-D cable
(not supplied)
~:
Video signal flow
Tip
Set "Input-A Signal Sel." in the SET SETTING menu to "Auto" or "Computer."
If
the input signal
does not appear properly, set it to "Computer."
(&'
page 39)
1m
• The projector accepts VGA, SVGA, XGA, SXGA, SXGA+, WXGA signals. However, we
recommend that you set the output mode
of
your computer to WXGA mode for the external
monitor.
• To connect a Macintosh computer equipped with a video output connector
of
a type having two
rows
of
pins, use a commercially available plug adaptor.
•
If
you set your computer, such as a notebook type, to output the signal to both computer's display
and the external monitor, the picture
of
the monitor may not appear properly. Set your computer
to output the signal only to the external monitor.
For details, refer to the computer's operating instructions supplied with your computer. For
settings
of
the computer, consult with the manufacturer
of
the computer.
• The HDMI connector
of
this projector is not compatible with DSD (Direct Stream Digital) Signal
or CEC (Consumer Electronics control) Signal.
• When connecting an HDMI cable to the projector, make sure the A mark on the lower part
of
the
HDMI input
of
the projector and the A mark on the connector
of
the cable
is
set at the same
position.
21
To Next Page
Loading...
Need help?
General