Step
3:
Adjusting the Picture Position
Project
an
image
on
the screen and adjust the picture position.
1,2 4 6
,...--....t~
8 7
1
Rear remote
5
control
detecto%
t+t--2
1-+++--6
1 After connecting the AC cord to
the projector, plug the
AC
cord
into a wall outlet, connect all
equipment, and remove the lens
cover.
The
1/(9
(On/standby) switch lights in
red and the projector goes into standby
mode.
2 Press the
1/(9
(On/standby)
switch to turn on the projector.
The
1/(9
(On/standby) switch flashes in
green, then lights in green.
22
3 Turn on the equipment
connected to the projector.
Refer to the operating instructions
of
the
connected equipment.
4 Press INPUT to project the
picture on the screen.
Each time you press the button, the input
indication and equipment to be projected
change.
(&'
page 27)
To Next Page
Loading...
Need help?
General