1-11. Replacement of Filter
Preparation
1. Remove the front panel. (Refer to “4-2. Front Panel”.)
Procedure
1. Warp the filter retainer and remove it from the holes of the power supply fixing plate.
Warping
direction
Warping direction
Projections
Filter retainer
Power supply fixing plate
Front panel
Note
When attaching the filter retainer, put it in between the two projections with the warping direction as shown in the
illustration.
2. Remove the six screws, then remove the power supply fixing plate.
XVS-9000-C/XVS-8000-C/XVS-7000-C/XVS-6000-C
1-22
To Next Page
Loading...
Need help?
General
