STARTING AND OPERATING 2–25
The parking aid system will be activated
when the automatic transmission selector
lever is shifted into “R” position and the re-
verse lamps are turned on when ignition
switch is in ON or engine is running. At this
time, you can figure out the distance be-
tween your vehicle and obstacles with the
alarming sound.
PARKING AID SYSTEM*
• Each end side sensor and two center
portion sensors will activate the alarm
when the distance between your vehicle
and the obstacle is around 120~80cm
and 100~80cm respectively.
: Intermittent alarm
• When the distance is between 80~50cm
: Regular alarming
• When the distance is between 50cm
: Alarm stays on
Beep
“ON”
Beep
“OFF”
Beep
“ON”
Beep
“OFF”
Beep
“ON”
Beep
“OFF”
Tips on Parking Aid System
The alarm will not work or improperly work
under following cases:
A. Certain obstacles that sensors can
not detect
1. Wires, ropes, chains.
2. Cotton, sponge, clothes, snow that ab-
sorb ultrasonic waves.
3. Obstacles lower than the bumper.
B. The sensors can not detect
1. When they are frozen.
2. When they are blocked by snow or mud.
3. When they are receiving other ultrasonic
signals (metal sounds and air-braking
noises from heavy commercial vehicles).
4. When a high-power radio is turned on.
New Rexton02_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 25 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
