3–28 INSTRUMENTS AND CONTROLS
HIGH BEAM SWITCH
To turn on the high beam headlights push the
lever towards the instrument panel with the
low beam headlights on.
The headlight high beam indicator light in the
instrument panel comes on when the head-
lights are on high beam.
For low beam headlights, pull the lever back
towards the steering wheel to the normal
position.
PASSING LIGHT SWITCH
To flash the high beam, pull the lever to-
wards the steering wheel and release it.
The lever will return to the normal position
when released.
The high beam headlights stay on as long
as you hold the lever.
TURN SIGNAL SWITCH
Move this lever up to the stop position to
signal a right turn.
Move this lever down to the stop position to
signal a left turn.
When the turn is completed, the signal will
cancel and the lever will return to the nor-
mal position. When changing lanes, move the
switch part way and hold it there. When re-
leased, the switch will spring back to the
normal position.
CAUTION
Battery will discharge.
Do not leave the lights on while en-
gine is off.
NOTE
The light switch must already be in
the
position.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 28 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
