3–30 INSTRUMENTS AND CONTROLS
AUTOMATIC WIPER CONTROL
SWITCH
The interval of wiper swings can be ad-
justed by twisting the control knob upward
or downward when the windshield wiper
switch is in AUTO position.
F : Fast interval
S : Slow interval
AUTO Position Recognition Function
• When you start the engine with the wiper
switch “AUTO” position, the wiper will
operate once to remind you that the
wiper switch is in “AUTO” position.
• When you move the wiper switch to
“AUTO” from “OFF” position, the wiper
will operate once.
CAUTION
If the wiper switch is at “AUTO”
position, place turn it to “OFF” po-
sition before stopping the engine.
CAUTION
•
Auto position recognition, espe-
cially in winter, may reduce the
life span of the wiper blade. Make
sure the wiper switch is at “OFF”
position unless it rains.
•
During winter time, the wiper blade
can be frozen to windshield. Wiper
operation while blade is frozen can
damage wiper motor. Be sure to
check the blade before operation.
•
The wiper operation on dry wind-
shield can scratch glass and wear the
blade prematurely. Do not operate
wiper when the windshield is dry.
•
When you clean the windshield
over the sensor with damp cloth,
the wiper may operate suddenly. It
could cause serious injury. Make
sure to place the wiper switch and
ignition switch to “OFF” position
when not in use.
•
Make sure to place the wiper
switch to “OFF” position before
wash-ing the vehicle.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 30 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
