3–36 INSTRUMENTS AND CONTROLS
Setting a Desired Speed
1. To operate the cruise control, acceler-
ate to your desired speed using the
acceleration pedal more over 36km/h.
2. When the desired speed is reached,
push up the ACCEL.SET. switch of a
cruise control lever or push down the
DECEL.SET. switch for 1 second per one
switching and then release the accelera-
tion pedal, slowly.
3. Now, the vehicle is cruised by this sys-
tem with set speed.
4. And you can set to other vehicle speed
again with above steps after accelera-
tion pedal intervention during cruise con-
trol running.
CAUTION
When cleaning the inside of tailgate
window, be careful not to scratch or
damage the defogger wires.
Do not clean inside of tailgate win-
dow with sharp instruments or win-
dow cleaners containing abrasives.
NOTE
In snowy condition, use this defog-
ger switch only after removing any
snow from the tailgate window.
NOTE
The defogger uses a lot of power and
can discharge the battery.
•
Do not use the defogger when
starting the vehicle or the engine
is not running.
•
Switch off defogger when tailgate
window is clear.
CRUISE CONTROL*
Cruise control is an automatic speed control
system that maintains a desired driving
speed without using the accelerator pedal.
The vehicle speed must be greater than 36
km/h to engage cruise control. This feature
is especially useful for motorway driving.
CAUTION
Improper use of cruise control could
be dangerous.
•
Do not use on winding roads.
•
Do not use in heavy traffic.
•
Do not use on slippery, wet roads.
This could result in a loss of control,
collision, and/or personal injuries.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:31Page 36 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
