Edition Manual Chapter Page
2014-09-09 Workshop Manual, GGP Park 2 Chassis and body 2
2.1 Rear wheel
2.1.1 Assembly
1. Push the hub on the shaft until it rests
against the transmission body.
2. Assemble the washer and the circlip onto the
shaft. The washer shall rest against the
circlip.
3. Check the key and assemble it in the groove,
against the washer.
4. Assemble the rear wheel without tightening
the nuts.
5. Measure the distance (X) between the front
wheels and adjust the rear hubs until the
distance between the rear wheels is the
same (X).
Pull out the hubs until the measure (Y) is the
same at the both sides.
Note!
If the measures between the wheels front
and rear not is the same, the machine will
be hard to steer.
6. Tighten the two allen screws, using a 8 mm
allen key.
The tightening shall be performed in two
steps. Tighten first to 18 Nm and then, finally
to a torque of 24 Nm.
7. Assemble the rear wheel and the protecting
cover.
Asembly when tyre chains are used
To give place for the tyre chains, the distance X
can be increased. If necessary until the hub
rests against the washer.
X
X
Y
15/17 mm box spanner
To Next Page
Loading...
Need help?
General
