WORKSHOP MANUAL
T...102/122 - TC...102/122
C) Crown fasteners
Some pin ends (6) are secured by crown fasteners
(7). During dismantling, these fasteners are always
da maged and lose their hold, so they should never
be reused.
On assembly, make sure it is inserted in the right di-
rection and push the fastener (7) onto the pin using
a pipe or socket spanner (8) with the right diameter,
so that it can be tted without deforming the faste ner
“crown”.
IMPORTANT A deformed fastener should always be
replaced.
PRACTICAL HINTS
CHAPTER REVISION FROM ... PAGE
2.4 0 2018 2 of 2
To Next Page
Loading...
Need help?
General
