WORKSHOP MANUAL
T...102/122 - TC...102/122
Map of functional units
On reassembly ensure the exact positioning of the belt
(6) with respect to the pulleys, the small side wheels
and the containment guides [see 8.2.4], with special
reference to its passage through the belt guide fork
(5).
Always ret the dust covers (10) of the wheels (8).
When assembly is completed …
Ret the engine pulley.
Adjust the drive engagement.
Ret the collector channel.
Tighten the spring of the stretcher.
Dismantle the engine pulley
Remove the collector channel.
It is advisable to slacken the transmission belt to work
on the parts involved more easily. This is done by
slackening the stretcher.
Dismantle the drive pulley (1) and the stretcher pulley
(2), xed by nuts (3) and (4) respectively, and slacken
the belt guide (5) enough to free the belt (6).
Slacken o the xing nuts (7) of both small wheels
(8) and remove the pin (9) from the brake rod to allow
passage of the belt.
Validity
General informations
Related topics
[
4.3] Drive belt adjustment
[
5.3] Removal of the collector channel
[
5.5] Removal of the engine
[
8.2] Belts assembly
Tightening torques
3 - 4 Nuts for pulleys ........................... 25 ÷ 30 Nm
7 Nuts for small wheels ...................... 25 ÷ 30 Nm
REPLACEMENT OF THE DRIVE BELT
CHAPTER REVISION FROM ... PAGE
6.4 0 2018 1 of 1
To Next Page
Loading...
Need help?
General
