WORKSHOP MANUAL
T...102/122 - TC...102/122
B) Sharpening and balancing
Always sharpen both cutting edges of the blade (2)
u sing a medium grade grinder. Sharpening must on-
ly be done from the rounded side, removing as lit tle
material as possible.
The blade is to be replaced when the cutting edge has
worn down to 10 mm.
Using the appropriate equipment, check the ba lance
to make sure that there is a maximum die rence of 2
grams between one side and the other.
REMOVING, SHARPENING AND BA LANCING
THE BLADES
CHAPTER REVISION FROM ... PAGE
4.9 0 2018 2 of 2
max 10 mm
To Next Page
Loading...
Need help?
General
