WORKSHOP MANUAL
T...102/122 - TC...102/122
B) Removing the front cover
Remove the dashboard [see point “A”].
Remove the parking brake lever knob (21) or (22) and
dismantle the front guard (23) xed to the chassis by
six screws (24).
Disconnect the accelerator cable terminal from the
engine and disconnect all remaining electrical con-
nections and the starter cable (where present).
The dashboard (13) can be removed at this point; it is
x ed to the chassis by two upper screws (14), co vered
by plastic caps, and three lower screws (15).
On assembly, follow the steps described in reverse,
being careful to restore wheel alignment with the
steering wheel, install the Belleville washer (3) with
the concave part facing down and fully tighten the
screw (2).
CHAPTER REVISION FROM ... PAGE
5.4a 0 2018 2 of 2
REMOVING THE DASHBOARD
AND FRONT COVER
To Next Page
Loading...
Need help?
General
