Stihl 034 Series User Manual

7034, 036, 036 QS
Hexagon nut M5 Carburetor (initial) 2.0
Hexagon nut M5 Carburetor (final) 3.5
Spline screw IS-M5x20 Cylinder/crankcase (036, 036 QS) 11.5
Spline screw IS-M5x20 Cylinder/crankcase (034) 10.5
M14x1.25 Spark plug 25.0
Spline screw IS-M5x20 Ignition module (with washer) 8.0 2)
Spline screw IS-M4x12 Oil pump/crankcase 3.5
1) Micro-encapsulated
2) Threadlocking method: medium strength adhesive (e.g. LOCTITE 243)
3) Threadlocking method: high strength adhesive (e.g. LOCTITE 649)
4) Threadlocking method: high strength adhesive up to 250°C (e.g. LOCTITE 272)
5) Threadlocking method: high strength adhesive (e.g. LOCTITE 270)
6) Degrease taper with cleaning agent (e.g. Somentor 33)
Use the following procedure when refitting a DG or P screw in an existing thread:
– Place the screw in the hole and rotate it counterclockwise until it drops down slightly.
– Tighten the screw clockwise to the specified torque.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread
and weaken the assembly.
Note:
Power screwdriver settings for polymer:
– Plastoform screws max. 600 rpm
– DG screws max. 500 rpm
3.6 Special Accessories
3.6.1 For User
3.6.2 For Service
Intake air preheating kit
Intake air preheating kit
.325", 8-tooth rim sprocket kit
.325", 7-tooth rim sprocket kit
3/8", 7-tooth rim sprocket kit
3/8", 7-tooth spur sprocket
.325", 7-tooth spur sprocket
Gasket set
Carburetor parts kit
Gasket panel
034, 036, 036 QS
1125 007 1035 (036)
1125 007 1004 (034/034S)
1125 007 1000
1125 007 1001
1125 007 1002
1125 640 2000
1125 640 2005
1125 007 1050
1128 007 1065
0457 281 0604
Fastener Thread size For component Torque
Nm
Remarks

Stihl 034 Series Specifications

General

Brand	Stihl
Model	034 Series
Category	Chainsaw
Language	English