Online version - not for reprint
51MS 270, MS 280
7.6 Ignition System Troubleshooting
Engine does not run
Master Control lever/slide control
or separate stop switch
in position "1"?
Check the spark plug:
– Smeared with oil, black?
– Sooted?
– Electrode gap correct?
– Contacts shorted?
Clean the plug, reset
or replace
Check spark plug boot:
– Firmly seated on plug (leg spring)?
– Leg spring hook in center of
ignition lead?
– Boot damaged?
If necessary, install new spark plug boot
and/or leg spring
Test ignition system with
ZAT 3 or ZAT 4
(use ZAT 3 as main spark gap
– see TI 32.94)
1
To Next Page
Loading...
Need help?
General
