4-12 ELECTRICAL
STARTER MOTOR
REMOVAL
Prior to removing starter motor :
• Disconnect battery cables from battery.
1. Remove bolt 1 and flywheel cover 2.
2. Remove bolt 3 and negative - battery cable 4.
3. Remove nut 5 and positive + battery cable 6 from
magnetic switch of starter motor.
4. Disconnect Red lead wire 7 from terminal “S” of starter
magnetic switch.
5. Remove two bolts 8 securing starter motor.
Remove starter motor 9 and dowel pins 0.
INSTALLATION
Installation is reverse order of removal with special attention
to the following steps.
• Apply engine oil lightly to motor mounting bolts before in-
stalling.
• Install starter motor and tighten mounting bolts securely.
" Starter motor mounting bolt :
8 mm 23 N
.
m (2.3 kg-m, 16.5 lb.-ft.)
10 mm 50 N
.
m (5.0 kg-m, 36.0 lb.-ft.)
To Next Page
Loading...
Need help?
General
