8-14 POWER TRIM AND TILT
PTT MOTOR INSTALLATION
Installation is reverse order of removal with special attention to
the following steps.
1. Ensure that drive joint 1 is aligned and firmly inserted into
gear pump assembly.
2. Fit O-ring 2 to PTT motor.
3. Check level of PTT fluid contained in PTT pump
case. If level is low, add recommended PTT fluid until level
with mating surface of PTT motor.
4. Ensure that faces of PTT motor and pump unit are free of
dirt or debris.
When attaching PTT motor to PTT pump case, ensure that
tip of armature shaft fits firmly into drive joint 1.
5. Tighten four bolts to specified torque.
" PTT motor screw : 5 N
.
m (0.5 kg-m, 3.6 lb.-ft.)
6. Pour recommended PTT fluid into reservoir until specified
level.
7. Perform air bleeding procedure.
See AIR BLEEDING section on page 8-3.
Armature shaftArmature shaft
To Next Page
Loading...
Need help?
General
