Suzuki DF140Z User Manual

18-24 DF90/115/140 “K8” (’08) MODEL
MODIFICATION OF HARNESS CONNECTION
For operating the digital gauge, disconnect the gauge connector A from gauge connector B, and connect
the gauge connector A to the SDS communication connector as shown in the illustration.
DIGITAL GAUGE AND RELATED PARTS CONNECTION
Standard gauge Digital gauge
SDS communication
connector
SDS communication
connector
Cap
Cap
B Gr O/Y Y
B Gr O/Y Y
Bl/B G/W P/W
Bl/B G/W P/W
Bl/B G/W P/W
Bl/B G/W P/W
Gauge connector
Gauge connector
Gauge connector
Gauge connector
Active hub
Battery
Fuel gauge
Volt meter
Trim gauge
Speedometer
Tachometer
Interface Module
Connect this connector to “ENGINE 1”
or “ENGINE 2” of the hub.
Remote control wire
Interface module harness adaptor
Interface harness
Active hub power harness
3” gauge harness
2” gauge harness
Jumper wire
6 pin connector cap
Connect the gauge connector
of engine harness to SDS
communication connector.
(See MODIFICATION OF
HARNESS CONNECTION)

Suzuki DF140Z Specifications

General

Brand	Suzuki
Model	DF140Z
Category	Outboard Motor
Language	English