2-20 PERIODIC MAINTENANCE
BATTERY SOLUTION LEVEL CHECK
Battery solution level should be between UPPER level and
LOWER level.
If level is low, add distilled water only.
Once the battery has been initially serviced, NEVER
add diluted sulfuric acid, or you will damage the bat-
tery. Follow the battery manufacture’s instructions for
specific maintenance procedures.
BATTERY SOLUTION GRAVITY CHECK
Measure gravity of battery solution using hydrometer.
Battery solution gravity : 1.28 at 20°C
\ 09900-28403 : Hydrometer
BOLT AND NUTS
Inspect initially after 20 hours (1 month) and every 100
hours (6 months).
Check that all bolts and nuts listed below are tightened to their
specified torque.
ITEM
TIGHTENING TORQUE
N
.
m kg-m lb.-ft.
Cylinder head cover bolt 11 1.1 8.0
Flywheel bolt
Power unit mounting bolt
Clamp bracket shaft nut 43 4.3 31.0
Gearcase bolt
Propeller nut 55 5.5 40.0
245 24.5 177.0
23 2.3 16.5
50 5.0 36.0
8 mm
10 mm
55 5.5 40.0
THREAD
DIAMETER
16 mm
6 mm
22 mm
10 mm
18 mm
Lower mount bolt / nut
12 mm 60 6.0
43.0
FUEL MIXTURE CHECK (O
2
FEEDBACK)
Perform every 2 years.
To perform fuel mixture check (O
2
feedback) operation, use
personal computer and Suzuki Diagnostic System software.
For fuel mixture check (O
2
feedback) operation, refer to “Suzuki
Diagnostic System Operation Manual”.
NOTE:
See “O
2
FEEDBACK SYSTEM” section on page 3-34 before
starting O
2
feedback operation.
To Next Page
Loading...
Need help?
General
