PERIODIC MAINTENANCE 2-5
(3) Screw new filter on by hand until filter O-ring con-
tacts the mounting surface.
(4) Tighten filter 3/4 turn from point of contact with
mounting surface using an oil filter wrench.
" Engine oil filter : 14 N
.
m (1.4 kg-m, 10.0 lb.-ft.),
3/4 turn.
(5) Install STBD side cover.
6. Install gasket and oil drain plug.
Tighten engine oil drain plug to specified torque.
" Engine oil drain plug : 13 N
.
m (1.3 kg-m, 9.5 lb.-ft.)
Do not re-use gasket once removed. Always use a new
gasket.
7. Pour recommended engine oil into oil filler opening, then
install oil filler cap.
Engine oil amounts
Oil change only : 5.5 L (5.8 / 4.8 US / Imp. qt)
Oil filter change : 5.7 L (6.0 / 5.0 US / Imp. qt)
Full level
line
Low level
line
8. To reset oil change reminder system’s operation time to
zero (cancellation) ;
(1) Turn ignition key to “ON” position.
(2) Pull out emergency stop switch plate 1.
(3) Pull up emergency stop switch knob 2 three times in
seven seconds. A short beep will be heard if cancella-
tion is successfully finished.
(4) Turn ignition key to “OFF” position, then set emergency
stop switch plate 1 in original position.
NOTE:
See “OIL CHANGE REMINDER SYSTEM” section on page 3-32.
9. Start engine and allow it to run for several minutes at idle
speed.
Check oil filter for oil leakage.
Turn off engine and wait for approx. two minutes, then re-
check engine oil level.
To Next Page
Loading...
Need help?
General
