CHASSIS 5-9
INSPECTION AND DISASSEMBLY
TIRE ........................................................................... "2-17
SPOKE NIPPLES....................................................... "2-18
WHEEL BEARINGS................................................... " 5- 5
AXLE SHAFT ............................................................. "5- 5
WHEEL ...................................................................... "5- 5
BRAKE DISC
Inspect the brake disc for wear or damage. If any abnormal wear
is found, replace the brake disc with a new one.
BRAKE DISC INSPECTION
.... .. ... .. ... .. ... .. .. ... .. ... .. ... .. .. ...
"5-15
• Remove the brake disc.
REASSEMBLY AND REMOUNTING
Reassemble and remount the front wheel in the reverse order of
removal and disassembly. Pay attention to the following points:
WHEEL BEARINGS
... ... .. ... .. ... .. .. ... .. ... .. ... .. .. ... .. ... ..... .. .. ... .. "5-5
BRAKE DISC
• Tighten the brake disc nuts to the specified torque.
# Brake disc nut: 8.5 N·m (0.85 kgf-m, 6.0 lb-ft)
FRONT AXLE
• Tighten the front axle nut to the specified torque.
# Front axle: 44 N·m (4.4 kgf-m, 32.0 lb-ft)
NOTE:
After remounting the front wheel, pump the brake lever a few
times to check for proper brake operation.
• Install the new cotter pin.
To Next Page
Loading...
Need help?
General
