5-14 CHASSIS
BRAKE CALIPER REASSEMBLY AND
REMOUNTING
Reassemble and remount the brake caliper in the reverse order
of removal and disassembly. Pay attention to the following
points:
• Wash the caliper bore and piston with the specified brake
fluid. Thoroughly wash the dust seal groove and piston seal
groove.
) Specification and classification: DOT4
#
PISTON SEALS
• Install the piston seal
1 and dust seal
2 as shown.
BRAKE CALIPER HOLDER
• Apply SUZUKI SILICON GREASE to the brake caliper holder.
* 99000-25100: SUZUKI SILICONE GREASE
• Install the spring
3.
* Wash the brake caliper components with new brake
fluid before reassembly.
* Do not wipe the brake fluid off after washing the
components.
* When washing the components, use the specified
brake fluid. Never use different types of fluid or
cleaning solvents such as gasoline, kerosine, etc.
* Replace the removed piston seals and dust seals
with new ones.
* Apply brake fluid to all of the seals, brake caliper
bores and pistons before reassembly.
To Next Page
Loading...
Need help?
General
