2-59
BEFORE DRIVING
78KS0-37E
Odometer/Trip meter/Thermometer
When the ignition switch is turned to the
“ON” position, the display (C) shows one of
the following three indications, trip meter A,
trip meter B and thermometer. Also, the
display (D) shows the odometer reading.
78K086
(f) Trip meter A
(g) Trip meter B
(h) Thermometer
(i) odometer
To switch the display indication (C), push
the TRIP knob (1) quickly.
Odometer
The odometer records the total distance
the vehicle has been driven.
Trip meter
The trip meter can be used to measure the
distance traveled on short trips or between
fuel stops.
You can use the trip meter A or trip meter B
independently.
To reset the trip meter to zero, push and
hold the TRIP knob (1) for about 2 seconds
when the display shows the trip meter.
Thermometer
The thermometer indicates the outside
temperature.
79K067
If the outside temperature nears freezing,
the message shown in the above illustra-
tion will appear on the display.
NOTE:
The outside temperature indication is not
the actual outside temperature when driv-
ing at low speed, or when stopped.
Setting mode
79K068
When the ignition switch is in the “ON”
position and the vehicle is stationary, you
can enter the setting mode of the informa-
tion display by pushing and holding the
MODE/ILL knob (2) for more than 3 sec-
onds.
• To select the setting that you want to
change, turn the MODE/ILL knob (2) left
or right.
• To change the setting, push the MODE/
ILL knob (2).
• To exit the setting mode, select “Back”
and push the MODE/ILL knob (2).
(f) (i)
(g)
(h)
EXAMPLE
CAUTION
Keep track of your odometer reading
and check the maintenance schedule
regularly for required services.
Increased wear or damage to certain
parts can result from failure to per-
form required services at the proper
mileage intervals.
EXAMPLE
To Next Page
Loading...
Need help?
General
